Note that these parameters does not affect ZMODEM receiving. You can change the ZMODEM parameters for sending by editing the ZmodemDataLen and ZmodemWinSize lines in the section of the setup file like the following: When ZMODEM receiving(upload) command of remote host is executed, the file selection dialog of ZMODEM sending is opened. If you run the ZMODEM Send command at the host, the ZMODEM Receive command of Tera Term is automatically activated. To enable the auto activation of the ZMODEM Receive / Send command, edit the ZmodemAuto line in the section of the setup file like the following: YMODEM timeout value can be specified in seconds.
NAK mode: Timeout value for first packetĢnd. XMODEM timeout value can be specified in seconds.ġst. If not specified, " a command for XMODEM receipt" will not be sent. Specify a command for XMODEM receipt to be sent from Tera Term. You can automatically start the receipt of file by sending "a command for XMODEM receipt" to host immediately before transmitting a file. To log data packets of XMODEM to the file XMODEM.LOG, edit the XmodemLog line in the section of the setup file like the following: To accept file attributes(size, type and timestamp, etc) of Kermit, edit the KmtFileAttr line in the section of the setup file like the following: However, the kermit server must support this feature. To transmit and receive extended-length packets of Kermit, edit the KmtLongPacket line in the section of the setup file like the following: To log data packets of Kermit to the file KERMIT.LOG, edit the KmtLog line in the section of the setup file like the following: To log data packets of B-Plus to the file BPLUS.LOG, edit the BPLog line in the section of the setup file like the following:
To escape all control characters in the B-Plus file transfer, edit the BPEscCtl line in the section of the setup file like the following. If you run the B-Plus Send command in the host, the B-Plus Receive command of Tera Term is automatically activated.Įscaping all control characters in the B-Plus protocol To enable the auto activation of the B-Plus Receive command, edit the BPAuto line in the section of the setup file like the following: For example, if the received file is "abc.txt" and the same file name already exists in the local disk, the received file is renamed to be "abc1.txt". Then, the received file is renamed automatically to avoid overwriting. To avoid this overwriting, edit the AutoFileRename line in the section of the setup file like the following: If the same file name already exists in the local disk, the existing file is overwritten by the received file. When a file is received by using the Kermit, Zmodem, BPlus or Quick-VAN protocol, the file name is given by the remote host. File transfer (Tera Term setup file) Auto renaming of a received file to avoid overwriting
0 kommentar(er)
